Edge-lighting Sloped Ceiling Standoffs Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Edge-lighting Sloped Ceiling Standoffs. Edge Lighting Sloped Ceiling Standoffs User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
C
M3 SET SCREW
1.5MM ALLEN
WRENCH
THREADED
POST
1
#8 SCREW
INTEGRATED
WASHER-NIPPLE
ANCHOR
4
MS-SL-_
- This product is ETL listed for indoor dry locations.
- The product is intended to be used with Edge Lighting
Monorail systems only.
- Use Monorail standoffs where the Monorail sections join
together and approximately every 3 feet max throughout
the Monorail run.
Monorail Sloped Ceiling Standoffs
Installation Instructions for
904-MS-SL-02
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
A
Install the Standoff Hardware
1: Hold the Monorail section against the ceiling or use a plumb
bob to mark the sloped standoff locations onto the ceiling
(this may require more than one person).
2: Tap the anchors onto the marked locations up to the
threaded portion with a hammer.
3: Screw the threaded portion of the anchors in with a Phillips
screwdriver.
ANCHOR
CEILING
2
B
4: Mount the integrated washer-nipple to the anchor with the
#8 screw provided.
5: Tighten the threaded post completely onto the integrated
washer-nipple.
1: Push the sloped standoff connector completely into the
threaded post and tighten the M3 set screw with the 1.5mm
Allen wrench.
SAVE THESE INSTRUCTIONS!
3
THREADED POST
5
Sloped Standoff Connector
Canopies
Installation for Monorail Power Feed
1
SLOPED STANDOFF
CONNECTOR
© 2009 Edge Lighting. All Rights Reserved.
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - Canopies

CM3 SET SCREW1.5MM ALLEN WRENCHTHREADED POST1#8 SCREWINTEGRATEDWASHER-NIPPLEANCHOR4MS-SL-_- This product is ETL listed for indoor dry locations.- The

Page 2

4M3 SET SCREW1.5MM ALLEN WRENCHJOINING POSTSLOPED STANDOFF CONNECTOR2150 WattSloped Standoff Connector Surface TransformerInstallation for 1: See the

Page 3

3HMONORAILCONICAL NIPPLETHREADED HOUSINGM3 SET SCREW1.5MM ALLENWRENCH2: Slightly loosen the M3 set screw on the conical nipple of each of the stan

Page 4

4LMONORAILCONICAL NIPPLETHREADED HOUSINGM3 SET SCREW1.5MM ALLENWRENCH5: Slightly loosen the M3 set screw on the conical nipple of each of the stan

Commentaires sur ces manuels

Pas de commentaire