Edge-lighting Harley with Gobo Manuel d'utilisateur télécharger pdf

SAVE THESE INSTRUCTIONS!

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

M-HAR-5-GO-_

FJ-HAR-5-GO-_

M2-HAR-5-GO-_

- This product is ETL listed for indoor dry locations.

- This product is not restricted to certain height installation.

It is approved to be used at any height above the floor.

- Applicable accessories are Hexcell Louver, Glass Lenses,

Gobo, and lens holder.

2: Place an optional optical accessary and lamp into the lamp

holder, and secure them by tightening the lens holder ring to

the lamp holder.

3: Push the socket completely onto the lamp pins.

Use MAX 75 Watt, Type MR16 Front Glass Cover Halogen

Lamp.

CAUTION: To reduce risk of a burn or electrical shock during

lamping, disconnect the power to the fixture.

Installation Instructions for Harley with Gobo Holder

Install the Fixture

904-HAR-5-GO-01

To reduce the risk of fire, electrical shock, exposure to

excessive UV radiation, or injury to persons:

- Use this fixture indoors only.

- Do not look directly at the lamp while the fixture is on.

- RISK OF FIRE: Use only the type of lamp and maximum

wattage indicated in this instruction manual.

- Never cover the halogen lamp with anything other than a

lamp shield provided by Edge Lighting and never place

flammable material close to the fixture.

- Never turn the fixture on and off by connecting and

disconnecting the halogen lamp.

- Do not touch the fixture head, shade or lamp shield while

the fixture is on. These surfaces may be VERY HOT.

- Do not touch lamp at anytime. Use a soft cloth. Oil from skin

may damage lamp.

- It is normal for a new halogen lamp to produce minor

smoke when first turned on.

- Do not operate the luminaire with a missing or damaged

shield.

- Turn power off and allow to cool before replacing lamp.

IMPORTANT SAFETY INSTRUCTIONS

IMPORTANT INFORMATION

LENS HOLDER RING

ALLEN WRENCH

remove the lens holder ring from the lamp holder.

Use a small Allen wrench or a pen point to loosen and

LAMP

SOCKET

LAMP HOLDER

LENS HOLDER RING

OPTICAL

ACCESSORY

LAMP

1 2 3 4

Résumé du contenu

Page 1 - Harley with Gobo Holder

SAVE THESE INSTRUCTIONS!1718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: [email protected]_F

Page 2

2LAMP HOLDER4: Screw the two metal rods completely into the threaded holes on the lamp holder of the Harley fixture.C4SPRINGGOBOGOBO HOLDER RINGD5

Page 3 - Connector (MC-FJ-_)

3G12: Install the harley with the gobo to the corresponding system by referring to drawing H through K on page 3 and 4.14: If necessary

Page 4 - FJP-4RD-_)

41: Use fingers to tighten the Fast Jack fixture connector into the Fast Jack canopy connector.FAST JACK CANOPYCONNECTORFAST JACK FIXTURECONNECTOR

Commentaires sur ces manuels

Pas de commentaire

Edge-lighting Harley with Gobo Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Edge-lighting Harley with Gobo. Edge Lighting Harley with Gobo User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Edge-lighting Harley with Gobo