Edge-lighting 3 Inch Flexible Goof Connector Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Edge-lighting 3 Inch Flexible Goof Connector. Edge Lighting 3 Inch Flexible Goof Connector User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
SS-CGF
Installation Instructions for Soft Strip Goof Straight & 3" Flex Connector
1
904-SS-CGF-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2011 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
IMPORTANT INFORMATION
Install the Soft Strip into Goof Connector
A
NOTE: The goof connectors are used to connect two soft strips
together when the ends are cut by accident. Please note that
when joining two cut section of the soft strips together, the total
length of the soft strip should not exceed the maximum
allowance as is indicated in soft strip spec sheet or the
installation instructions.
- This product should be used with Edge Lighting Warm
White and Very Warm White soft strip only.
SS-CGF-3IN
1: Cut the copper junction in proper location at the end of the
soft.
2: Using a sharp knife remove the clear coat from the copper
junction.
CLEAR COATING
1/8" AMOUNT OF
COPPER CONTACT
SOFT STRIP
CONDUCTIVE AREA
NOTE: About 1/8" of the copper contact on the soft strip is
needed for the goof connectors. The SS1 and SS3 soft strip can
be cut in the middle of the copper junction, however the entire
SS2 copper junction is needed.
CUT HERE FOR
SS1 & SS3
2
B
3: Pull out the front tab of the goof connector to clear the
opening.
4: Insert the copper junction of the cut soft strip completely
into the goof connector and push the front tab in to lock the
goof connector in place.
5: Repeat step 4 for the other side and the other soft strip
section.
3" FLEX GOOF
CONNECTOR
SOFT STRIP
OPEN FRONT TAB
CLOSED TAB
3
4
4
1
NOTE: Make sure the red wire is in line with +12VDC or
+24VDC marking of the soft strip.
CUT TO THE END
OF CONTACT FOR SS2
1
Vue de la page 0
1

Résumé du contenu

Page 1 - IMPORTANT INFORMATION

SS-CGFInstallation Instructions for Soft Strip Goof Straight & 3" Flex Connector1904-SS-CGF-011718 W. Fullerton AveChicago, IL 60614Tel: 773-

Commentaires sur ces manuels

Pas de commentaire