1Section One: Basic Configuration Options1718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-935-5613www.purelighting.cominfo@purelighting
1011: Install mounting straps behind the drywall (suggested spacing is every 32") by threading a drywall screw into the perforated ma
1122: Using the marked locations on the drywall, carefully make holes in the channel flange using the provided square drill with counter s
1229: Line up the red wire side of the power connector with the “+24VDC” marking on the Soft Strip. Push the male connector of the Soft St
1335NOT INSTALLEDCORRECTLY35: Snap the lens back onto the channel sections. Ensure lens is fully seated.35Z17Section Five: Zig Zag InstallationCORRECT
14CHANNELTRAP DOOR FRAMELENS7: Snap the lens into the assembled trap door frame and channel BEFORE cutting to length. This ensures a proper fi
1516: Insert the 90° joiner bracket halfway into the mitered channel corner. Tighten the two M4 set screws on each joiner bar with a 1.5MM
1624: Apply ultra-thin drywall tape along edges of channel to prevent cracking of plaster after installation. DO NOT overlap strips of dry
1730: Continue applying LED soft strip in the side of channel. Carefully bend the LED soft strip 90° to match the channel corner.30LED SOF
Section Two: Standard Horizontal InstallationAJUNCTIONBOX1MOUNTING BRACKETPHILLIPS SCREWADJUSTABLE MOUNTING BAR1: Mount each adjustable mounting bar t
C6" FIXEDJAB SAW4: Cut a section of drywall using a 6" fixed jab saw or other appropriate tool to expose the mounting plate area.4E8: Co
TRAP DOORFRAMECHANNELSECTION14: Cut the assembled trap door frame, channel, and lens to match the desired lit installation length.LENSDESIRED LIT LENG
21: Drill and countersink the channel at stud markings.22: Properly secure the channel to the wall using drywall screws. Ensure all screw heads
26: Remove the blue contractor’s tape from the inside of the channel. Clean the channel surface with alcohol to remove any dust or debris
31: Snap the lens back onto the channel. Ensure lens is fully seated.TCORRECT73131NOT INSTALLEDCORRECTLYSection Three: Vertical InstallationJUNCTIONBO
8DRYWALL1.05"5: Determine the desired length of lit installation area and mark on wall. The total installation length cut will need to be
91: Install junction box and low-voltage power.2: Measure and mark installation length, allowing for 0.75" extra space at junction box for po
Commentaires sur ces manuels