Edge-lighting Puck LED Manuel d'utilisateur télécharger pdf (Page 1)

Installation Instructions for Puck LED

904-PUCK-04

Recessed Mount Installation

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

1: Remove the mounting ring and discard it.

2: Mark the location where the LED Puck light is going to be

recessed.

3: Drill out the marked location with a 2.5" circular saw.

4: Feed the LED Puck light wires through the cut out hole and

snap the LED Puck light into the hole.

5: Repeat the steps 1 through 4 for the remaining pucks and

then follow the "Power the Puck Lights" steps.

PUCK-RD-3W-90D-30K-SA

SAVE THESE INSTRUCTIONS!

- This product can be installed as recessed or surface

mount.

- It is recommended to use the HUB-4P or HUB-8P to power

the Puck Lights.

- This product works with a 12 Volt AC LED electronic

transformer (TE-60L-12) & is dimmable with a low voltage

electronic dimmer.

- This installation instruction shows typical installation.

IMPORTANT INFORMATION

SURFACE

2.5"

(6.35cm)

Surface Mount Installation

SURFACE

NOTCH

NOTE: Omit the steps below if surface mounting the Puck Lights.

1: Remove the mounting ring.

2: Use the mounting ring as a template to mark the screw

location where the LED Puck light is going to be installed.

3: Use a 1/16" drill bit to drill pilot holes on marked locations.

4: Feed the LED Puck wires through the mounting ring. Hold

the cord against the notch on the mounting ring while

installing the mounting ring to the pilot holes with the

provided two Phillips screws.

5: Pull the cord through the notch on the mounting clip and

snap the LED puck light into the mounting ring.

6: Repeat the steps 1 through 5 for the remaining pucks and

then follow the "Power the Puck Lights" steps.

MOUNTING

RING

LED PUCK

FIXTURE

MOUNTING

RING

FIXTURE

PHILLIPS

SCREW

LED PUCK

1 2

Résumé du contenu

Page 1 - Puck LED

Installation Instructions for Puck LED904-PUCK-04Recessed Mount Installation1718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-935-5613ww

Page 2 - TYPICAL WIRING DIAGRAM

2Power the Puck Lights1: Mark the location where the hub is going to be installed. 2: Use a 1/16" drill bit to drill pilot holes on marked locati

Commentaires sur ces manuels

Pas de commentaire

Edge-lighting Puck LED Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Edge-lighting Puck LED. Edge Lighting Puck LED User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Edge-lighting Puck LED Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Edge-lighting Puck LED. Edge Lighting Puck LED User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Edge-lighting Puck LED