Edge-lighting Bubble Ball Manuel d'utilisateur télécharger pdf

FJ-BBCL-_

Installation Instructions for Fast Jack Bubble Pendant

904-FJ-BUBBLE-02

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

SAVE THESE INSTRUCTIONS!

- This product is ETL listed for indoor dry locations and

approved to be used at any height above the finished

floor.

IMPORTANT INFORMATION

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, exposure to

excessive UV radiation, or injury to persons:

- Use this fixture indoors only.

- Do not look directly at the lamp while the fixture is on.

- RISK OF FIRE: Use only the type of lamp and maximum

wattage indicated in this instruction manual.

- Never cover the halogen lamp with anything other than a

lamp shield provided by Edge Lighting and never place

flammable material close to the fixture.

- Never turn the fixture on and off by connecting and

disconnecting the halogen lamp.

- Do not touch the fixture head, shade or lamp shield while

the fixture is on. These surfaces may be VERY HOT.

- Do not touch lamp at anytime. Use a soft cloth instead as oil

from skin may damage lamp.

- It is normal for a new halogen lamp to produce minor

smoke when first turned on.

- Do not operate the luminaire with a missing or damaged

shield.

- Turn power off and allow to cool before replacing lamp.

Adjust the Fixture Height

1: Feed the coaxial cable through the glass shade, and rest

the glass shade over the socket assembly.

COAXIAL CABLE

2: Cut the coaxial cable to the desired height (H) with a sharp

cutter. The overall fixture height is measured from the

bottom of the glass shade to the end of the coaxial cable.

SOCKET ASSEMBLY

GLASS SHADE

1 2 3 4

Résumé du contenu

Page 1 - Fast Jack Bubble Pendant

FJ-BBCL-_Installation Instructions for Fast Jack Bubble Pendant904-FJ-BUBBLE-021718 W. Fullerton AveChicago, IL 60614Tel: 773-770-1195Fax: 773-935-561

Page 2

2C3: Loosen the two M4 set screw on base of the coaxial fixture connector with the 2mm Allen wrench provided. Do not remove these set screws.4

Page 3 - CIRCUIT #2

3CIRCUIT #1CIRCUIT #212N12N10: Push the strain relief tube completely into the coaxial fixture connector. Make sure the slot on the strain relie

Page 4 - Install the Lamp

CAUTION: To reduce risk of a burn or electrical shock during lamping, disconnect the power to the fixture.4Install the Lamp1: Lift the glass shade up

Commentaires sur ces manuels

Pas de commentaire

Edge-lighting Bubble Ball Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Edge-lighting Bubble Ball. Edge Lighting Bubble Ball User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Edge-lighting Bubble Ball