Edge-lighting 2" Power Feed Canopies Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Edge-lighting 2" Power Feed Canopies. Edge Lighting 2" Power Feed Canopies User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
SAVE THESE INSTRUCTIONS!
MP-2SQ-1-_
- This product is ETL listed for indoor dry locations.
- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).
- This product should be installed by a qualified electrician.
- This product installs to Edge Lighting 2" electrical box only.
1: Turn the power to electrical box off.
2: Connect each low voltage wire coming from the remote
transformer to one power feed canopy wire with a wire nut.
Monorail 2" Square Single Power Feed Canopy
Installation Instructions for
Install the Canopy
1
904-MP-2SQ-1-03
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
NOTE: The low voltage wires should be present in the 2"
electrical box. Refer to the instructions provided with the remote
transformer to install the transformer and the low voltage wires
before proceeding with the steps below.
A
2
2
3: Place all wires inside the 2" electrical box.
4: Secure the power feed canopy to the 2" electrical box by
tightening the two provided #8-32 screws with the 3/32
Allen wrench.
3/32 ALLEN WRENCH
#8-32 SCREW
B
4
4
3
© 2009 Edge Lighting. All Rights Reserved.
Vue de la page 0
1 2

Résumé du contenu

Page 1 - Install the Canopy

SAVE THESE INSTRUCTIONS!MP-2SQ-1-_- This product is ETL listed for indoor dry locations.- Minimum electrical box volume must be 6 cubic inches (98 c

Page 2

2Install the Monorail to Power Feed CanopycCAP3/8-24 SET SCREWPOWER HOUSING211: Unscrew the cap from power housing.2: Slightly loosen the 3/8-24 set s

Commentaires sur ces manuels

Pas de commentaire