Edge-lighting 600W/24V Remote Recessed Transformer Manuel d'utilisateur télécharger pdf

TR-600-24

Installation Instructions for

120 Volt Input to 24 Volt Single Feed Output

600 Watt Recessed Magnetic Transformer

904-TR-600-24-03

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: 773-770-1195

Fax: 773-935-5613

www.edgelighting.com

[email protected]

SAVE THESE INSTRUCTIONS!

- Do not install this lighting system in a damp or wet

location.

- Do not conceal or extend bus bar conductor through

building wall.

- To reduce the risk of fire and burns, do not install this

lighting system where the insulated open bus bar

conductors can be shorted or contact any conductive

materials.

- To reduce the risk of the system overheating and possibly

causing a fire, make sure all the connections are tight.

- Do not install fixture assemblies closer than six inches, or

as specified in the fixture installation instructions, to

curtains or similarly combustible materials.

- Turn the electrical power off before modifying the lighting

system in any way.

- The fixtures used with the Edge Lighting systems must be

identified for use with the corresponding Edge Lighting

systems.

- Minimum volume of the electrical box must be 6 cubic

inches (98 cubic centimeters).

- The system is "ETL" listed for USA and Canada only when

all the products used are supplied by Edge Lighting.

- RISK OF FIRE: This product must be installed by a

qualified electrician. Turn the power to the electrical box off

during installation. Read the "Important Safety Instructions"

before installation.

- This product is suitable only for indoor dry locations and

approved for the use at any height above the finished floor.

- This product may be dimmed only with a low voltage

magnetic dimmer. Using a dimmer other than specified may

work initially, but will eventually cause transformer failure

and void the warranty. The dimmer must be derated as

indicated by the dimmer manufacturer.

- A typical installation is shown. Specific installation must be

in accordance with the local electrical codes.

- TO REDUCE RISK OF FIRE, it is important to wire the

recessed transformer for the system as described in this

installation instruction.

- Load the circuit of the recessed transformer to MAXIMUM

600 Watt.

- This product may require some modification (remodeling) to

existing wall where the transformers is to be mounted. The

wall studs should be 16" apart.

GENERAL INFORMATION IMPORTANT SAFETY INSTRUCTIONS

1 2 3 4

Résumé du contenu

Page 1 - SAVE THESE INSTRUCTIONS!

TR-600-24Installation Instructions for 120 Volt Input to 24 Volt Single Feed Output600 Watt Recessed Magnetic Transformer 1904-TR-600-24-031718 W. Ful

Page 2 - Voltage Wires

LOW VOLTAGE WIRE SIZE CHART2Install the Transformer1: Select the location between the wall studs (16" apart) where the transformer is to be m

Page 3 - Connect the 120 Volt Wires

COM T T2T3T4T143CConnect the 120 Volt Wires1: Install the 120 Volt power wires to the transformer.2: Insert the hot power wire inline with the black t

Page 4

Commentaires sur ces manuels

Pas de commentaire

Edge-lighting 600W/24V Remote Recessed Transformer Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Edge-lighting 600W/24V Remote Recessed Transformer. Edge Lighting 600W/24V Remote Recessed Transformer User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Edge-lighting 600W/24V Remote Recessed Transformer